Our Products

*FORTRON/SOURCE 150W POWER SUPPLY FOR MATX, 2.03V

SKU: AO17150


+ Click to enlarge

Product Details

FJRIGJWWE9R0Product_Descriptions:spec
Features
  • High efficiency
  • Low Ripple & Noise
  • Output over voltage protection
  • Short circuit protection on all output
  • Resettable power shut down
  • Approved by UL, CSA, TUV, IEC, NEMKO CB & CE
  • Internal 12 VDE fan provided
  • 100% burn-in under high ambient temperature (50 C)
  • Vacuum-impregnated transformer
  • MTBF: 100k hours at 25 C
  • 100% Hi-pot tested
  • Line input fuse protection
  • Passive PFC (Power Factor Correction) circuit at 230Vac

 

Input Requirements
  • Voltage: 190-264 VAC
  • Frequency: 47 Hz to 53 Hz
  • Input current: 4.0A maximum / 230 V, 50Hz

 

Specification
  • Remote ON/OFF Control: The power shall accept a logic collector level which will
    disable / enable all output voltage (excluding +5V standby)
  • Temperature Range: Operating 0C - 50C; Non-operating: -20C - +65C
  • Temperature coefficient: 0.01%C
  • Transient Response: Output voltage recovers in less than 1 ms max.
    following a 25% load change
  • Hold up time: 10.0ms minimum at 230V/50Hz.
  • Dielectric withstand: Input/output 1800 VAC for 1 second,
    input to frame ground 1800 VAC for 1 second
  • Humidity: 5-95% RH
  • Efficiency: 60% Min, 70% typical at full load
  • Power good signal: turn-on delay 100ms to 500ms
  • Overload protection: 150% Max
  • Over voltage protection: +5V output: 6.5V,
    +3.3V output: 4.6V,+12V output: 15.5V
  • Fan Noise killer Optional

 

Output Requirements
  Minimum Load Normal Load Maximum Load load
Reg.
Line
Reg.
Ripple
& Noise
+3.3V 0.5 8.3A 11.5/16.7A 5.0% 1.0% 50mV P-P
+5V 1.0A 6.3A 16/12.6A 5.0% 1.0% 50mV P-P
+12V 2.0A 2.0A 10.0A 5.0% 1.0% 120mV P-P
-12V 0.0A 0.15A 0.3A 10.0% 2.0% 120mV P-P
-5V 0.0A 0.1A 0.2A 10.0% 2.0% 120mV P-P
+5Vsb 0.0A 1.0A 2.0A 5.0% 1.0% 50mV P-P
(1) +3.3V & +5V total output not exceed 118W
(2) +3.3V & +5V & + 12V total output not exceed 165W